Guides

How to Replace a Car Key Battery, and What It Costs

Almost every car key runs on a single coin cell, usually a CR2032, which costs a pound or two and takes about five minutes to change at the kitchen table. The number you need is printed on the battery already in the key.

Written by Anthony Haley, auto locksmithUpdated 18 November 20266 minute read

How to tell it is the battery and not the key

A flat battery is the single most common thing mistaken for a broken key, and the two fail in completely different ways. A battery dies gradually. A key dies suddenly.

The first sign is range. A fob that used to open the car from across a car park starts needing ten feet, then five, then you are standing with it touching the door handle. That slow shrinking is a battery every time. If the buttons worked perfectly yesterday and do nothing at all today, with no warning and no drop in range beforehand, a battery is the less likely answer.

The quick test. Hold the fob directly against the door handle and press unlock. A battery with a little life left will usually manage at point-blank range even when it cannot manage from two feet. If it works touching the car and nowhere else, buy a battery before you ring anybody.

Two more things worth knowing before you assume the worst. Most cars will still start with a completely dead fob, because the manufacturer expects this to happen. On a push-button car you hold the fob against the start button or a marked spot on the steering column, and the car reads the chip by induction rather than by radio. And almost every fob hides a metal emergency blade inside it, which opens the driver door by hand.

What battery your key takes

The honest answer is that the number is written on the cell sitting in your key right now, and that is more reliable than any list. Open the fob, read the number, buy that. Four types cover the vast majority of cars on UK roads.

BatteryWhat it looks likeWhere it turns up
CR203220mm across, 3.2mm thick. The thick one.By far the most common. Most remote and flip keys, and a large share of proximity fobs.
CR202520mm across, 2.5mm thick. Same width, visibly thinner.Common in slimmer fobs and in keys that hold two cells rather than one.
CR201620mm across, 1.6mm thick. The thin one.Older remotes, and some keys that stack two of them together.
CR245024mm across and thick. Noticeably bigger.A number of newer proximity and smart keys, where there is room for a larger cell.

A CR2025 will physically fit where a CR2032 belongs and it will work, badly, for a few months instead of a few years. If the contacts feel loose when you close the fob, you have bought the thin one by mistake.

Buy a sealed pack from a shop with turnover rather than a loose cell from a market stall. Coin cells lose charge sitting on a shelf, and a cheap multipack that has been boxed for two years can test fine and then fail inside a month.

Opening the fob without breaking it

This is the step that costs people money, because a cracked case is a far more expensive problem than a flat battery. Fobs are designed to come apart, but almost never where people try to open them.

1

Take the emergency blade out first

Nearly every fob has a release catch, a small button or a sliding tab, which frees a metal key blade. Pulling that blade out often exposes the seam you are meant to use, and sometimes exposes the battery cover directly.

2

Find the real seam

Look around the edge for a notch, a slot or a shallow groove. That notch is the designed entry point. The gap running round the middle of the fob is usually not it, and levering there is what snaps the clips.

3

Use the blade, not a screwdriver

The flat of the emergency blade is the right thickness and will not gouge the plastic. A screwdriver concentrates force on one point and marks the case. Twist gently rather than prying hard.

4

Note which way up the cell sits

Before you lift the old battery out, look at which face is upwards. The positive side is marked with a plus and is usually, but not always, the side you can see.

5

Handle the new cell by the edges

Fingerprints on the flat faces leave a film that interferes with the contact. Hold it by the rim, drop it in, press the case back together until it clicks all the way round.

What it costs

The battery itself is the cheap part. What varies is who puts it in.

Doing itRough costWorth knowing
The cell on its ownA pound or two, less in a multipackThe same CR2032 sold as a car key battery and as a watch battery is the same cell at a different price.
A shop fitting it for youUsually a few pounds on topFine on a simple remote. On a proximity fob, ask whether they have opened that type before.
An auto locksmithNot usually worth a call-out on its ownIf you are already having a key cut or a fob repaired, the battery goes in as part of the job.

Nobody should be charging you a call-out fee to change a coin cell. If a key is otherwise healthy, this is a do-it-yourself job and anyone telling you otherwise is selling you something else. The time to ring somebody is when the battery was not the problem.

When the battery was not the problem

Sometimes the new cell goes in and nothing changes. That is useful information rather than a wasted afternoon, because it rules out the cheapest cause and points at the next one.

  • Nothing at all, even touching the handle. Usually a broken solder joint on the battery contact inside the fob, or a cracked board. Both are repairable and neither needs a new key.
  • One button works and the others do not. The rubber contact pads under the buttons wear through. A repair job, not a replacement.
  • The car unlocks but will not start. That is not the remote at all. The transponder chip in the key is a separate component from the battery and does not rely on it.
  • It worked, then stopped again within weeks. Either the cell was old stock, or water has been in the fob and the corrosion is eating the contacts.

If any of those describe your key, the fault is inside the fob or in the car rather than in the battery, and the next place to look is set out in why a car key stops working.

How long a battery should last

Three to four years is normal for a remote key that gets daily use. Proximity and keyless fobs are harder on batteries because they are awake and listening rather than asleep until you press something, and two years is a fair expectation there.

A few things shorten it. A key kept next to a phone or a laptop all day gets woken repeatedly. A spare left in a drawer for years can go flat without ever being used, because coin cells self discharge whether you press them or not. And a fob that has been through a wash cycle will often work for weeks and then fail, as the corrosion spreads.

Change both keys at once. If one fob has gone flat after four years, the other one is the same age and roughly as far gone. Two cells cost pennies more than one, and you avoid doing this twice in a fortnight.

If it turns out not to be the battery

Most of the time it is, and this is a five minute job you never need to ring anybody about. When it is not, the fob itself can usually be mended rather than replaced, and that is the cheaper answer almost every time.

Send a photograph before you buy anything

A picture of the open fob and the number on the cell is usually enough for me to tell you whether you are looking at a battery, a repair or a new key. No charge for the answer.

Related guides and services
the types of car key explained, what a replacement key costs, remote and fob repair, car key replacement.

Frequently asked questions

Can you replace a car key battery yourself?

Yes, on almost every key. It takes about five minutes and needs no tools beyond the emergency blade already inside the fob. The one case where it is worth handing over is a sealed or glued fob, which a few manufacturers use, where forcing it apart does real damage.

What kind of battery does a car key take?

A coin cell, and most often a CR2032. The exact number is printed on the face of the battery currently in the key, which is a better answer than any list because it is your car.

How much does it cost to replace a car key battery?

A pound or two for the cell if you fit it yourself. A few pounds more if a shop does it. There is no reason to pay a call-out charge for a battery alone.

What happens if my car key battery dies completely?

You can still get in and still drive. The emergency blade inside the fob opens the driver door by hand, and on a push-button car you hold the dead fob against the start button so the car can read the chip without radio. Check the handbook for where that spot is on your model.

My key still will not work with a new battery. What now?

The fault is in the fob or the car rather than the cell. Broken contacts, worn button pads and water damage are all repairable without a new key, and they cost a fraction of a replacement.

Does changing the battery mean the key has to be reprogrammed?

No, not on a normal battery change. The chip that talks to the immobiliser keeps its programming whether the battery is in or out. If a key does stop being recognised after a change, that points at a contact problem inside the fob rather than at lost programming.

Can I use a rechargeable cell instead?

No. Rechargeable coin cells run at a lower voltage than the lithium cells these keys expect, so the range is poor from the first day and gets worse quickly.

Is it worth having a spare key cut while I am at it?

Yes, if the car only has one key. A spare cut while one key still works is roughly half the price of a key made after the last one is gone, and a flat battery is a good reminder of how dependent you are on a single fob.

Scroll to Top